<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <html> <head> <META HTTP-EQUIV="Content-Type" CONTENT="text/html; charset=us-ascii"> <meta name=Generator content="Microsoft Word 10 (filtered)"> <style>  </style> </head> <body lang=EN-US link=blue vlink=purple> <div class=Section1> <blockquote style='border:none;border-left:solid black 1.5pt;padding:0in 0in 0in 4.0pt; margin-left:3.75pt;margin-top:5.0pt;margin-right:0in;margin-bottom:5.0pt'> Just to clarify the fix here.. I needed to add single quotes around the interface name with the “$” as well. For example in the services configuration: check_snmp_int!public!'FastEthernet0/2$' Thanks! Mike <div style='margin-left:.5in'> <div class=MsoNormal align=center style='margin-left:.5in;text-align:center'> <hr size=2 width="100%" align=center> </div> </div> From: Mike Koponick [mailto:mkoponick@redhawk.info] Sent: Thursday, February 16, 2006 11:38 AM To: Dennis Hopp; Nagios Users Subject: RE: [Nagios-users] Check_snmp_int.pl Dennis, Thanks for the tip. That worked! I suppose it’s time to dive into Perl ;-) Thanks! Mike -----Original Message----- From: nagios-users-admin@lists.sourceforge.net [mailto:nagios-users-admin@lists.sourceforge.net] On Behalf Of Dennis Hopp Sent: Thursday, February 16, 2006 9:33 AM To: Mike Koponick; Nagios Users Subject: RE: [Nagios-users] Check_snmp_int.pl Try: ./check_snmp_int -H 10.xx.xx.xx -C <community> -n GigabitEthernet0/1$ --Dennis <blockquote style='border:none;border-left:solid black 1.5pt;padding:0in 0in 0in 4.0pt; margin-left:3.75pt;margin-top:5.0pt;margin-right:0in;margin-bottom:5.0pt'> <div style='margin-left:.5in'> <div style='margin-left:.5in'> <div class=MsoNormal align=center style='margin-left:.5in;text-align:center'> <hr size=2 width="100%" align=center> </div> </div> </div> From: nagios-users-admin@lists.sourceforge.net [mailto:nagios-users-admin@lists.sourceforge.net] On Behalf Of Mike Koponick Sent: Thursday, February 16, 2006 11:18 AM To: Nagios Users Subject: [Nagios-users] Check_snmp_int.pl I’m using check_snmp_int.pl to check on interfaces on switches/routers, but can’t seem to have it look at a single interface. I think this is a “/” issue, but am not sure. When use the command: ./check_snmp_int -H 10.xx.xx.xx -C <community> -n GigabitEthernet0/1 I receive the following: GigabitEthernet0/1:UP, GigabitEthernet0/12:DOWN, GigabitEthernet0/10:UP, GigabitEthernet0/11:DOWN: 2 int NOK : CRITICA I only wish to see one interface, rather than all of them as some are not in use and *should* be down. Thoughts? Maybe it’s time for more coffee? Thanks! Mike </blockquote> </blockquote> </div> </body> </html>